- The heat pack is air-activated, do not open the pad packaging until you are ready to use it.
- Open the packaging and take out the heat pad.
- Note! Do not cut or damage the heat pad while taking it out.
- Remove the paper strip from the back side of the heat pad to expose the adhesive surface.
- Stick the heat pad with the adhesive side to the center of the paper target marked with circle.
- Note! There is no need to shake the heat pad, it will warm itself up in 3-5 minutes.
- Attach the paper target to the desired location.
- Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize thermal view, so that thermal pad is clearly visible.
- Perform zeroing procedure as described in the user manual of your thermal imaging device.
- With the help of the round shape and small diameter of the pad, deviations of point of impact can be eliminated in just a few shots.
Quantity in the box:
- 10 pcs. paper target size: 30 x 30 cm
- 10 pcs. carbon activated heating pads with adhesive side: 40 mm (heated surface)
Duration of pad remaining hot: 10-20 min, on cold surfaces (depends on weather conditions)
Ingredients: iron powder, activated carbon, vermiculite, salt, resin, water